Bathroom Installation (Cream / Sand) Linden Road, Bicester

Installed by BPI’s bathroom fitting team based in Bicester, this was both a surprising and challenging bathroom project to work on. Our original brief was that the shower was leaking and that the shower enclosure needed retiling and the floor too.

On stripping out the shower enclosure and taking up the first few floor tiles, a far larger problem was discovered. There had been a serious leak from the toilet and the chipboard floor and timbers under the tiles was almost completely rotten. The plasterboard on the walls lower down was also black with mould on the outer face due to some incorrect works when previously installed.

We stripped this bathroom back to the concrete block and reboarded the entire room. New pipework was run along the concrete floor and we then installed a new chipboard floor. 10mm cement board was installed over the top of this chipboard to form a sturdy, watertight surface for tiling.

A new stud wall was build to accommodate the shower enclosure again and once boarded, we tiled the shower enclosure. The floor was also tiled.

Another stud wall was built and a new concealed cistern was fitted behind with a push button. This was followed by a new back to wall toilet. The existing basin and towel radiator were reinstalled.

Find Out More About Our Bathroom Fitting Service

A full bathroom installation in Kings Sutton near Bicester & Banbury

Bathroom Installation (Cream) In Kings Sutton, Banbury

Completed by BPI, this was a great project to work on for some brilliant clients. This main family bathroom was in need of some TLC and a bit of an upgrade. Cream and brown were the main colours here.

The existing suite was removed and the walls were prepared and ready for tiling a level surface. The floor was lined with 6mm cement board and the floor was fully tiled. Two of the walls were tiled with large cream textured tiles and finished with a light cream grout. A square edge brushed steel tile trim was used to complete all edges.

A new mixer shower with drencher was fitted over a new bath. As the water pressure needed improving, we also installed a new shower pump.   A chrome towel radiator was also installed as well as a new toilet, basin with pedestal and bath panel.

A Dulux easy care paint was chosen for the two walls that required painting and some new skirting board was also installed. Finally, a couple of coats of paint were applied to the ceiling to finish off.